I received my module last night -YAY!
So I soldered the FTDI pins on and downloaded the config utility. I have readings from the sensors.
Initial Thoughts::
-GUI looks very nice
-Telemetry was a bit choppy at first, regardless of what i set the refresh values at. However, I disconnected and then reconnected the module and the speed was greatly increased.
-The accelerometers appear to be extremely noisy. This is likely because I am not used to such a high resolution A/D converter - I will just keep playing with it
-The zedGraphs are nice, but the only ones that appeared to give me useful data that was not choppy was Roll, Pitch, and Yaw. Tom - could you please explain a bit which each does?
-I could not get the 3D portion to run. When I launch it, I get a config screen, choose resolution and then the 3d object finally renders, but is frozen and does not move.
-How can I test the pressure sensor? Looking at the telemetry data (height), I was unable to discern a correlation between values and me moving the sensor up and down about a .5 meters.
I didn't get to spend much time with it last night - I will spend more time soon. Although since the Olympics are about to begin I will be a bit tied up watching the TV
Thanks, Tom - so far everything is looking great! And the board is magnificent!
-Jamie