I attempted for the first time to use the gluonconfig firmware upgrade button. It looked like it was going to work, the dos command window opened and flashed some text, then it errored out. Tried a few times.
I was running gluonconfig 5.1 from the zip download and had 5b on the board. I reinstalled the bootloader then rtos pilot hex files from mplab (svn r77) and tried again with the same result.
I suspect there is something with the bootloader on my board that is not right. Is there a process spelled out somewhere to set up the bootloader or any other ideas? I'm assuming the boot loader installs to a chunk of memory exclusive of the other code. Is there some mplab configuration necessary here?
Would like to get this working to simplify future upgrades.
Thanks.