by lukasz » Sat Aug 28, 2010 11:09 am
Hi Tom,
I just came back from my vacation and started to play once again with latest firmware.
1. I have downloaded latest rtos_pilot from svn and burned it.
2. Also I have downloaded latest Gluonpilot configuration tool from SVN but it crashes after I try to run it.
3. Because above gluonpilot configuration tool crashes than I picked up latest one from download section (Gluonconfig_v0.4.zip).
4. I had run above gluonconfig tool, connected my gluonpilot, applied default settings, burned and reset it.
5. Than I have reconnected gluonpilot and applied latest configuration file that I saved using version 3.0. (write+burn+reset)
Issues that I see:
1. I see gyroscope and accelerometer readings under Configuration/Sensor tabs but still 3d cube is not working.
After I run 3d cube the cube is not responding to board movements. For previous releases I had no problems with this.
2. Previously I had problems saving KML Track files. Now this seem to work fine but once It opens in Google Earth I don't see this fancy diagram as on your video from main page. Is there any additional configuration I need to do to google earth?
3. GCS - I don't get any readings. No matter what I select there are no readings. I managed to get once the pressure reading but after selecting different option it stop working.
Let me know if you need any additional information.