Hi All,
I have almost finished my plane setup and started to play with configuration.
Manual mode seems to work fine - steering surfaces move as expected. Note that I use PWM signals - 5 channels.
I modified Hitec HFS-05MS receiver and pulled out PPM signal but I had large disturbances - after I powered on the plane, after a minute all servos and engine went crazy. I tried different channels but the result was always the same. I decided not to use this receiver as I don't want any unpredictable behavior during flight.
Having PWM signals from my second receiver all seems to work fine.
After configuring RC input, servos and control in GluonConfig tool I started to play with stabilized mode.
When I move the plane around (pitch, roll) all steering surfaces act as expected . I was so happy to see this working.
After reading http://gluonpilot.com/wiki/Stabilized_flight (Flight!section) I decided to move aileron stick in stabilized mode to see if steering surfaces act as expected - if my understanding is correct, in stabilized flight when I move aileron stick to left, the plane should roll to left and keep 35 degrees max for roll(this is how I set in Gluonconfig). After moving the aileron stick to its max positions steering surfaces didn't move at all.
Is my understanding of above wrong or something is not working here?
I would like to test all "on ground" before I go out into the field and fly.