Hello, some weeks ago I had a big crash when I tried to take off with my fly-wing on manual mode . The stator and rotor parts from the brushless motor, flew away. I joined the parts again and it works well but, after another crash at take off I had bad experiences (twice). TO take off, the motor remained spinning high even after I pulled down the throttle channel on the transmitter to abort. I will not use the motor again (SK3 from HK). I switched off the main battery plug while takes the plane with one hand.
So i want connect for safe a switch by myself, like a BEC on/off . Where I must put it? between ...
a) ... receiver and gluonboard?
b) ... gluonboard and ESC?
c)... battery and ESC?
I suppose at power wire.
Thanks for the feedback.