Dear Friends,
Recently I bought Futaba T6EX PWM RC with Futaba S3003 servos.
I'm trying to configure my gluon hardware ver.0.1 with firmware 0.8 with this RC.
The problem is that despite accurately following all the instructions I cannot
put the elevator channel to work correctly in manual and stabilize mode.
I did the settings this way:
*I set my RC signals to comply with the directions of RC tab page.
*My elevator moves reverse in manual but OK in stabilized/auto.
*I reversed elevator servo in servo tab page.
*My elevator has become normal for manual but reverse for stabilize/auto.
That's it......! The elevator response is always opposite for the manual/stabilized modes.
it can only be OK if I reverse the elevator channel on my rc.
Now elevator works correctly both for the manual and stabilized mode.
But the elevator signal bar on the rc tab page moves in wrong direction...!
I spent third day attempting to configure my gluon but without avail.
However a search on the net revealed that the futaba S3003 sevos
supplied with my new T6EX has an unusual counter clockwise direction.
Could this be the reason that my manual and stabilizing signals stay
opposite to each other.......? Can somebody kindly help....?
Kang.