by peters » Thu Mar 31, 2011 9:36 pm
Hi Tom,
I downloaded the firmware 0.51-DEV from download section to the 0.1J board successfully. Then I continue on Bench testing to RC input section. When I tried to reboot from Gluonconfig at first, it didn't work. And I see a number of unexpected errors so I re-download the firmware 0.51 again.
However, RC input still does not show anything. When I connect PWM2-5 to the receiver, I use a single line connection between signal (of that input) to the PWM input on the board. I verified that radio works, receiver works (attach another servo to another channel on receiver to check), and Gluonconfig doesn't see any R/C input at all.
Another issue is that when I reboot the board after "Burn", everything seems to be stuck. I had to "Load default" button before IMU data comes out. However, the data seems to be weird as the plane would start upside down. Please let me know if you have solved this before. I tried to read down the forum but couldn't relate to anyone.
Thank you,
Peter