Gluonpilot

Hi Tom,

Finally I found time to start playing with my module (SN 13). Unfortunately there is no information displayed on sensors tab. Initialization seems to be ok. See below what I got with a terminal program. There is nothing else after the last 'done'. Same thing with Gluon Config even with "Hide parsed lines" checkbox unchecked. Just in case I uploaded the last firmware available on Google code. No change.

The red led blink 2 or 3 times per second, I can read/write/burn the config from/to the module, etc etc.

Did I miss something ?

Thanks

Pierre


Gluonpilot v0.4 ALPHA [Aug 6 2010 17:48:23, config: 228 bytes, logline: 56 byte
s, navigation: 504 bytes, double: 4 bytes]
A Brown-out Reset has occurred
A Power-up Reset has occurred
2 MB flash found
Loading configuration...done
Opening GPS...timeout...done
Control task initializing...Sensors task initializing...done
Gps task initializing...done
Console input task initializing...done
Datalogger task initializing...done
Telemetry task initializing...done
done

Hi Pierre,

Glad to read you found some time to start playing

Can you press the "default" button? This loads some default configuration to the module.
In the first configuration tab page you should configure which telemetry output you want to receive from the module. A value of "0" means no values.

When you are satisfied with the configuration, you can press "Burn" to save the configuration to flash.

Tom,

Thanks for the info. That did the trick. I'm happy as in France number 13 (my SN) is considered unlucky

Normally first fly this week-end

Pierre