Throttle in autopilot failsafe but no automatically switch?

General discussions on the Gluon-project that don't fit elsewhere. If required, I will create more subforums.

Moderator: lukasz

Throttle in autopilot failsafe but no automatically switch?

Postby FPVChris » Sun Nov 17, 2013 9:28 pm

Hello!
I am using the Gluonpilot V1 with OSD and GPS.
I set up my reciever to fall back to lowest throttlesignal, the Groundstation shows (if i turn off my reciever) that the throttlesignal is that low that failsafe will be triggerd. The problem is, that the Gluonpilot wont change in Autopilotmode to bring my plane to the homeposition. The gluonpilotconfig shows: "throttle in autopilot failsafe" and the Throttlechannel lies at 907us, but the flightmode doesn't switch automatically.
Gps is fixed.
What is the problem here? Need your help, had a lot of throuble on my last flight.
Grettings Chris
FPVChris
 
Posts: 1
Joined: Sun Nov 17, 2013 8:29 pm

Re: Throttle in autopilot failsafe but no automatically swit

Postby Tom » Fri Nov 22, 2013 8:10 am

Fixed with a firmware image with smaller failsafe threshold.
User avatar
Tom
Site Admin
 
Posts: 1016
Joined: Fri Nov 13, 2009 6:27 pm
Location: Belgium


Return to General

Who is online

Users browsing this forum: No registered users and 2 guests

cron