Hello all,
bought my GP (v0.1n - sounds like a quite early version?) via eBay with GPS and first tried to connect to GCS on my laptop. Connection was successful, could upload a simple flightplan.
Then I tried to connect to the receiver and servos in my plane.
Due to open Jumper 2 and 3 I powered the GP either with an external battery (7,4) OR with the connected laptop. To power the servos I additionaly connected the main battery to the ESC (I hope, I haven´t misunderstood the methods of powering the module). For a short moment the ailerons react when I moved the GP-mainboard (while in manual mode!?), but that was all. After that I tried to connect with GCS again for configuration, but couln´t get a connection.
Now I´m not able to connect to the GP-mainboard longer than 5 seconds. After physical usb-connection both LEDs are on for a few seconds, then the red starts blinking (GPS is unplugged). When trying to connect with GCS, the connection get lost after 5 secs.
Does anybody have an idea how to get it to work or what went wrong?
Thanks for any replies!
Chris