always motion on z-axis

General discussions on the Gluon-project that don't fit elsewhere. If required, I will create more subforums.

Moderator: lukasz

Post a reply

always motion on z-axis

Postby SwissTom » Sat Feb 12, 2011 4:06 pm

I tried to get my board (39) running ...
Communication to PC is working, but I can't get the plane level.
There is always more then minus 1 G on Z-axis accelerometer.

I tried already different firmware versions, different configuration tools too ...
Version 0.5.1 brings funny height and temperature too :|

What is wrong here?
v51.jpg
v51.jpg (101.84 KiB) Viewed 5268 times
SwissTom
 
Posts: 1
Joined: Sat Feb 12, 2011 3:49 pm
Top

Re: always motion on z-axis

Postby Tom » Sat Feb 12, 2011 7:06 pm

Hi Tom,

Did yu calibrate the module? You can find on the wiki how to do it: http://gluonpilot.com/wiki/Stabilized_f ... he_sensors
User avatar
Tom
Site Admin
 
Posts: 1016
Joined: Fri Nov 13, 2009 6:27 pm
Location: Belgium
Top

Re: always motion on z-axis

Postby Tom » Thu Feb 17, 2011 6:46 pm

Tom,

Were you able to solve your problem?
User avatar
Tom
Site Admin
 
Posts: 1016
Joined: Fri Nov 13, 2009 6:27 pm
Location: Belgium
Top
Post a reply

Return to General

Who is online

Users browsing this forum: No registered users and 13 guests

Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
cron