Trying the Gluon with servos
Posted: Tue Mar 23, 2010 2:54 pm
Hi Tom,
I start my tries!
As my Gluon is ready I have connected to it 4 servos, on output numbers 1,2,3,4.
The rc input is setup like this: I use ppm pulse train
Channel 1 is motor
Channel 2 is roll
Channel 3 is pitch
Channel 4 is Yaw
Channel 6 is AP
Control is setup to aileron.
AP is setup in manual position
Observations:
When I move the throttle stick on the transmetter nothing happend on the Gluon servos
When I move the roll stick servo 1 and 2 are moving
When I move the pitch stick servo 3 moves
When I move the yaw stick nothing move
Control is setup to quadrocopter with write and burn
the observations are the same, it seems we have only 3 outputs.
I have some questions:
The explanation on the page "control" seems to be erroneus isn't it?: 1 up/down, 2 aileron1, 3 aileron 2, 4 motor
When I move the throttle stick nothing happend, but I see it moving on the RC input page, is this a trouble on my gluon?
What about the yaw? Not available for the moment?
Thanks
Eric
I start my tries!
As my Gluon is ready I have connected to it 4 servos, on output numbers 1,2,3,4.
The rc input is setup like this: I use ppm pulse train
Channel 1 is motor
Channel 2 is roll
Channel 3 is pitch
Channel 4 is Yaw
Channel 6 is AP
Control is setup to aileron.
AP is setup in manual position
Observations:
When I move the throttle stick on the transmetter nothing happend on the Gluon servos
When I move the roll stick servo 1 and 2 are moving
When I move the pitch stick servo 3 moves
When I move the yaw stick nothing move
Control is setup to quadrocopter with write and burn
the observations are the same, it seems we have only 3 outputs.
I have some questions:
The explanation on the page "control" seems to be erroneus isn't it?: 1 up/down, 2 aileron1, 3 aileron 2, 4 motor
When I move the throttle stick nothing happend, but I see it moving on the RC input page, is this a trouble on my gluon?
What about the yaw? Not available for the moment?
Thanks
Eric