by peters » Tue Apr 05, 2011 2:09 am
Hi Tom,
As for 5.2 hex file, I can not use Gluonconfig 5.2 to download the firmware to Gluonpilot board. Gluonconfig shows an error message and asks me if I want to retry. So if there is a command line, I would like to try that because the firmware download script after the error, the command line window closed too fast that I can't read anything.
As for Navigation, you are right that I can enter data and waypoints stays after reboot. However, now the problem with R/C input is either with the Gluonconfig doesn't show what's written and/or Gluonpilot does not remember the configuration for R/C input. How can I troubleshoot this issue? I tried reload, read from Gluonpilot board, Gluonconfig doesn't show the configuration that I set (Roll, Pitch, Yaw, Motor, AP) .. Sometime when I reboot Gluonpilot board, it doesn't accept any R/C input, I need to configure it to PWM before Gluonpilot can see the input.
I think I broke SCP1000 as I pressed it when I remove FTDI cable. How can it be fixed? Should I use solder iron to make sure that all connections are still intact?
Best,
Peter