configuration problem

[danielN]

Hello,
I connected the RC receiver to the Gluonpilot using 4 PWM channels. I was testing the firmware in manual mode, but the the output PWM signal does not change when I move the sticks on the RC transmitter even if the values shown in the Gluonconfig are correct.
After some debugging I noticed that the values of config.control.channel_pitch and the others have wrong values (-34) so I think it is a problem with reading the configuration values from the dataflash. Do you know how this problem can be solved?
Daniel

[Tom]

Hi Daniel,

I have not experienced such a problem myself.
Could you click "Default" (to load a default config to memory) and then "Burn". After that you can click "Reload" to load it from flash to memory. Click "Read" to see if you still have the problem.

Does this fix the problem? Are the other configuration values correct?

Tom