Re: Setup of RC receiver and another question
Posted: Tue Nov 09, 2010 2:31 am
Tom, thanks for your advice on the GPS.
On servo setup issue:-
When I power up the gluonmodule on the RC inputs page , all the readings are around 1500 1530 .
On the servos tab all the fields are showing zeros. The radio button to switch between the two fields to set the servo neutral value is blanked out so I can't switch it between the two settings. I cannot type a value into any of the settings values on the page.
I am not sure what should be the settings for the columns of radio buttons on the RC input tab
When I switch off the transmitter all the servos start twitching around a small amount - the same as RC servos often do when they are connected to the receiver and the trasmitter is switched off so I know they are powered and working.
Many thanks for your advice on this.
On servo setup issue:-
When I power up the gluonmodule on the RC inputs page , all the readings are around 1500 1530 .
On the servos tab all the fields are showing zeros. The radio button to switch between the two fields to set the servo neutral value is blanked out so I can't switch it between the two settings. I cannot type a value into any of the settings values on the page.
I am not sure what should be the settings for the columns of radio buttons on the RC input tab
When I switch off the transmitter all the servos start twitching around a small amount - the same as RC servos often do when they are connected to the receiver and the trasmitter is switched off so I know they are powered and working.
Many thanks for your advice on this.