navigation proplem

[Koaxpilot]

i think i hafe found the proplem ^^ i have never click reload
i´m so silly
but you must it add in the wiki

[Tom]

The correct way to do it is:
1. "Read"
2. Change the flight plan
3. "Write"
4. "Burn"
To verify:
5. "Reload"
6. "Read"

I'll add it later on to the wiki

On your next flight: please fly a bit higher
It's a good idea to fly manually of stabilized for a minute or so and then switch to autopilot mode (tip: make sure the plane is flying clockwise - from your left to your right - if you want it to circle)

[Koaxpilot]

i have my 3 fly ready.
but it is the same proplem , but i dont no if i have the ride way for write the flight plan .
i will test it tomorrow , have you a ather ideer abaut the proplem ?

[Koaxpilot]

i think i have found the proplem .
when i read the flight plan than it standig from line 1 to 36 this here :
UNKNOWN/UNSUPPORTED (255: 0 , 0 , -1 , -1)

how can i delete a line from the flight plan ? because when i push reload the line doesn´t delete

but when i write this flight plan , can work it or not :


i think this flight plan works

[Tom]

Hmm strange...
Can you do this:
1. "Read" the navigation data
2. Change line 1 to "CIRCLE_REL(0, 0, 80, 80)"
3. Change line 2 to "GOTO(1)"
4. Press "Write"
5. Press "Read"
-> Do you see the correct commands on line 1 and 2?
6. Press "Burn"
7. Press "Reload"
8. Press "Read"
-> Do you still see the correct commands on line 1 and 2?
9. Restart the module
10. "Read" the navigation data
-> Do you still see the correct commands on line 1 and 2?

[Koaxpilot]

yes
when i read the flight plan and chanche the line 1 and 2 and write and restart the modul and read again the flight plan than it have chanche the line 1 and 2 but on the ather lines it standing :
UNKNOWN/UNSUPPORTED (255: 0 , 0 , -1 , -1)

on my first 3 flight i have only write a new flight plan but haven´t read and correct the flight plan . i think that is the proplem

so ignor the autopilot the ather lines when on the first second lines standing this :
"CIRCLE_REL(0, 0, 80, 80)"
"GOTO(1)"

[lukasz]

I had same problem when upgraded from version 0.3 to 0.4.

I had to select each line (row) and change it to "Empty".
Than save + burn. I also did a reset.
After I reloaded the data all rows were blank and I could add commands.

hope this works out for you

[Tom]

The autopilot will only look at the first 2 lines, so there is no problem!

Is it possible the flight plan of your previous flight still had the "CLIMB" command?

[Koaxpilot]

yes on the first flight i have test the climp command

[Tom]

And the second one (last XML you have sent me)?