Bringing up the GluonPilot board
Posted: Mon Jun 14, 2010 3:20 pm
Hello Tom (and others),
I'm trying to bring up my new GluonPilot board and having some interesting difficulties. I have a serial port level shifter to connect to the board, and 5V power coming in from a bench power supply.
When I open the com port in RealTerm, I can see the data coming by. When I open it in the Config utility, I get nothing at all, not a single message.
I have the serial port set at 115200 8-N-1, and the Gluon Config v0.3
Any suggestions?
Thanks, Gabriel.
I'm trying to bring up my new GluonPilot board and having some interesting difficulties. I have a serial port level shifter to connect to the board, and 5V power coming in from a bench power supply.
When I open the com port in RealTerm, I can see the data coming by. When I open it in the Config utility, I get nothing at all, not a single message.
I have the serial port set at 115200 8-N-1, and the Gluon Config v0.3
Any suggestions?
Thanks, Gabriel.