Since i had not found enough informations regarding the current sensor I need your help regarding the connections.
Below there is the actual setup that i have:
As usual, the pack of questions :
1. I want to measure the current and voltage for the main battery ( battery1) and only the voltage for the aux battery(battery2). What modification i must do on the actual setup to make this possible? The below graph is correct regarding the connection for the current sensor for the bat1 ? If yes, how i must connect battery 2 to gluonpilot v2?
2. On the ground station - advanced configuration-sensors there are 2 fields to calibrate the readings for voltage, current. This calibration applies for both battery readings (bat 1 and bat 2) ? What are the steps that must be followed to calibrate the voltage reading , current - mAh consumed ?
Thank you,
Alex