Hi guys,
I have a couple of questions on the gluon board Tom if you don't mind answering:
-I need to supply a 5v 730mA current to my Digi Xtend wireless module through the FTDI connection while the gluon board is being powered by a battery separate from the servos, is this ok or is 730mA too much?
-On the Gluon board what are the two pads marked "PWR_SW" near the airplane image for?
-On another note I read somewhere that the GCS's map cache size is limited to only 22MB, is this right? can this be increased?
Regards!