Hey guys,
I searched the website but found nothing on this, is it possible to connect two batteries to Gluon in such way that both their voltages and remaining current get displayed in the GCS? How do I achieve this?
Regards,
Current+Voltage sensors
Moderator: lukasz
5 posts
• Page 1 of 1
Current+Voltage sensors
by Konkani_70 » Sun Jan 08, 2012 5:36 pm
- Konkani_70
- Posts: 11
- Joined: Fri Nov 18, 2011 10:16 am
Re: Current+Voltage sensors
by Tom » Mon Jan 09, 2012 4:46 pm
No, for the moment there is only 1 battery voltage input. There is one analog input available for any other use, but it still needs to be developed. I'm thinking to use this as current sensor input.
-
Tom - Site Admin
- Posts: 1016
- Joined: Fri Nov 13, 2009 6:27 pm
- Location: Belgium
Re: Current+Voltage sensors
by Konkani_70 » Mon Jan 09, 2012 5:59 pm
Thanks Tom. I might be speaking over my head here but isn't it possible to measure current with something like the AttoPilot Voltage and Current Sensor: http://www.sparkfun.com/products/10643
- Konkani_70
- Posts: 11
- Joined: Fri Nov 18, 2011 10:16 am
Re: Current+Voltage sensors
by Tom » Thu Jan 12, 2012 7:49 pm
Well yes it would be possible, but it's not yet implemented...
I might do it in the near future
Right now only voltage is measured
I might do it in the near future
Right now only voltage is measured
-
Tom - Site Admin
- Posts: 1016
- Joined: Fri Nov 13, 2009 6:27 pm
- Location: Belgium
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 4 guests