Gluonpilot

Hello,
I am building an FPV Nuri (Zephyr2 from Ritewing) unfortunately does not want me in the OSD. (GP HW version 0.1o)
I have a GoPro and to test a monitor. If I Did I Connecting both a picture when I'm using the OSD I get no picture, the expansion board and Gluonpilot have electricity, "OSD chip" has also 5V.
I tested version 0.8 and 0.7.2 I get the software up-
[01:44:28.68] Initializing OSD task ...
[01:44:28.68] found no OSD


Please help, I can measure anything on OSD chip?

Sorry for my late reply, I was out of town.
Normally the OSD should be detected at startup. The module was tested and it worked at that time... did you do something "unexpected"?
Feel free to send it back for checkup.

Hi Tom,

Thank you for your answer,
I'm on the board only swapped the Spannungsversorungung, we have already written so by email.
I've soldered Auserd PINs for FTDI.

I will send you the extension board tomorrow.

Thanks for the offer.