Gluonpilot

Good evening ,

I had the opportunity to buy 2 new Xbee Pro S2B modules. Reading on interned I observed that the setup ( pairing ) is different comparing with Xbee Pro S1 version ( this is what I am currently using).

If someone is kind enough to share the settings used for their Xbee Pro S2B modules ( air and ground) I will highly appreciate.

Thank you.

Anyone?

Hi Kempo,

We cannot share the settings because they could contain because I configure them as point - to - point devices, with as receiver the (hardcoded) address of the sender.
I'm sure you can find plenty of tutials on the internet how to do it (I think adafruit has them), just make sure they receive 57600 baud input from gluonpilot.
Let us know if you are unable to fix it

Tom wrote:Hi Kempo,

We cannot share the settings because they could contain because I configure them as point - to - point devices, with as receiver the (hardcoded) address of the sender.
I'm sure you can find plenty of tutials on the internet how to do it (I think adafruit has them), just make sure they receive 57600 baud input from gluonpilot.
Let us know if you are unable to fix it

Hi Tom,

I found some guidelines , on the ground is ok , if the weather will allow I will check the settings during flights . Hopefully I will have better xbee range.